If you don't get an e-mail with your access data, please make sure that you have already registered with us. As soon as you are registered, you can login with your e-mail address and your password.
In case you still have problems logging in, please turn to us by e-mail: anfragen@bonito.net
Bonito’s active antenna signal splitter "AntennaJet AAS300" is splitting the signal from one antenna to 3 different receivers simultaneously. The AntennaJet has a wideband (>300MHz) and ultra low noise amplifier and can share one antenna up to 3 different receivers which can be tuned to fully different frequencies, without switching the antenna cable or even pressing a button.
Due to the extraordinary high decoupling of the outputs (70dB), interference between the connected receivers is avoided. At the same time, the emission of interference to the antenna is effectively suppressed.
Up to three receivers can be connected. Non-connected outputs can remain open and don't need to be terminated. With its ESD-protection circuit the antenna input is protected against short or pulsed voltage surges or short circuits*.
* The ESD protection does not replace a lightning protection!
For RX only!
www.bonito.net/hamradio/antennajet-aas300/Frequency Range | 9KHz - 300MHz (-1dB) (@ 450MHz -6dB) |
---|---|
Connector | BNC |
Impedance | 50 Ohms |
IP3 | +35dBm typ. <10MHz +20dBm typ. >100MHz |
Power Supply | USB-B - Female |
Power consumption | max.50mA (5V DC) |
Insertion loss | max. 1.5dB typ. |
ESD input protection | 30KV; max. pulse power 350W (8/20µs) |
Input connector | BNC |
Maximum allowable input power | max. 0.5dB typ. |
Output connectors | BNC |
Dimensions | 115 x 90 x 32mm / 4.5 x 3,5x 1.2 in |
Weight | 300gr (10.58 oz) |
Conformity: | CE, FCC |
Made in Germany | Yes |