Through Window or Door Connector Cable with BNC or PL connectors. Thourgh window cable Description: Flat coax cable, for feeding coax cables through windows and doors, For use with coax-cable. Saves drilling, for windows, doors,caravans and balconies.  Typ. insertation loss: up to 30MHz: <1dB up to 50MHz: < 2dB up to 75MHz: < 3.5dB up to 150MHz: <5dB Length with connectors: 30 cm (11,8") Length of the ribbon cable 20 cm (7,9") RX-Only!

Adapterkabel  Adapterkabel aus Hyperflex 5 Low-Loss Koaxialkabel nach Ihren Wünschen. Viele der kleinen Einsteiger-SDR's wie SDRPlay, Airspy, Airspay HF+ etc. als auch die hochwertigen Winradio, Elad FDM-S1 und FDM-S2 etc. haben als externen Antennenanschluss eine SMA-Buchse. Wenn man nun eine externe Antenne oder einen Verteiler mit N Anschluss verwenden möchte, braucht man einen Adapter. Da die Standardadapter SMA auf N sehr groß bzw. viel zu massig für den jeweiligen Empfänger sind, leidet die SMA-Buchse am Empfänger und es kommt schon nach kurzer Zeit zu Kontaktschwierigkeiten oder sogar brechen der SMA Buchse. Im schlimmsten Fall muss die sogar SMA-Buchse im Empfänger sogar getauscht werden.  Die Adapterkabel können Sie zum Beispiel direkt an die SMA-Buche des Empfängers anschließen. Die angebotenen Längen dieses Adapterkabels haben wir aus der Praxis heraus gewählt. Andere Längen können wir natürlich individuell nach Ihren Wünschen anfertigen. Sollten Sie anderen Längen oder Stecker wünschen, kontaktieren Sie uns einfach. Auf die Schirmung kommt es an. Einige OM’s verwenden die dünnen Chinakabel, die einen geringen Durchmesser haben und somit sehr flexibel sind. Leider haben solche Kabel nur eine sehr geringe Schirmung von weniger als 40dB. Aber gerade auf den letzten Metern sollte man die höchste Schirmung haben! Warum? Im Haus wimmelt es von potentiellen Störern wie Schaltnetzteile, LEDs, Induktionsherd usw. Auch der PC und der Monitor sind meist in direkter Nähe und können unschöne Einflüsse haben. Aus diesen Gründen bieten Ihnen die Adapterkabel aus dem flexiblen Hyperflex 5 Koaxkabel an, das mit 105dB die aktuell höchst mögliche Schirmung hat. Damit werden Störeinflüsse bereits auf dem Weg in den Receiver stark minimiert.   Informationen zum Kabel Das Hyperflex 5 von Messi & Paoloni ist ein doppelt geschirmtes Low-Loss Koaxialkabel mit 5,4 mm Durchmesser und 50 Ohm Impedanz. Es ist ein sehr flexibles Koaxkabel, bei sehr niedrigem Dämpfungsverhalten und exzellenter Schirmung (105db!). Die gravierenden Unterscheide zwischen Hyperflex 5 und RG58U haben wir in einem Artikel ausführlich, mit vielen realen Beispielen beschrieben: zum Artikel Auch bei diesem Adapterkabel verwenden wir bei der Konfektionierung einen speziellen Schrumpfschlauch mit Heißschmelzkleber. Der Schrumpfschlauch mit Heißschmelzkleber dient sowohl der Versiegelung der Stoßstellen von Stecker und Hülse und gleichzeitig auch als Knickschutz. Zusätzlich bietet es weitere Anschlussmöglichkeiten via BNC. Wichtig! Diese Kabel werden für Sie zugeschnitten und unterliegen somit nicht dem Widerrufsrecht. Dämpfung bei 20°C FREQUENCY dB/100m dB/100ft 1,8 MHz  1,48  0,453,5 MHz  1,91  0,587,0 MHz  2,33  0,7110 MHz  2,63  0,8014 MHz  3,04  0,9321 MHz  3,64  1,1128 MHz  4,16  1,2750 MHz  5,58  1,70100 MHz  8,02  2,44144 MHz  9,66  2,94200 MHz  11,44  3,49400 MHz  16,37  4,99430 MHz  17,00  5,18800 MHz  23,48  7,161000 MHz  26,46  8,071296 MHz  30,50  9,302400 MHz  42,58 12,983000 MHz  48,1  14,664000 MHz  56,95  17,365000 MHz  65,29  19,906000 MHz  72,92  22,23 Bitte beachten Sie:  Diese Kabel sind Maßanfertigungen und somit vom späteren Umtausch ausgeschlossen! Gesamtlänge des Kabels: Kabelzuschnitt +/- 3% + Steckverbinder

Adapter cable RG 316DS (RG 316D) PTFE coaxial cable according to your requirements. Many of the small entry level SDR's like SDRPlay, Airspy, Airspay HF+ etc. as well as the high quality Winradio, Elad FDM-S1 and FDM-S2 etc. have as external antenna connector a SMA socket. If you now want to use an external antenna or a distributor with N connector, you need an adapter. Since the standard adapters SMA to N are very large or much too massive for the respective receiver, the SMA socket on the receiver suffers and it comes after a short time to contact difficulties or even break the SMA socket. In the worst case, the even SMA socket in the receiver must even be replaced. You can connect the adapter cable, for example, directly to the SMA socket of the receiver. The offered lengths of this adapter cable we have chosen from practical experience. Other lengths we can of course make individually, according to your wishes. If you need other lengths or connectors, just contact us. Information about the RG316DS PTFE coaxial cableThe RG316DS is a 29mm diameter double shielded PTFE coaxial cable with 50 ohm impedance. The RG316DS is double shielded with two superimposed silver plated copper braid, has a much thicker inner conductor and a huge temperature range from -75 to +200deg. It is a very flexible coaxial cable, with good attenuation characteristics and a shielding of 70dB. We have described the serious differences between good coaxial cables and RG58U in an article in detail, with many real examples: to the article. You will immediately notice the higher weight of the connectors used. The PTFE dielectric ensures lowest insertion loss and a smooth frequency response. Also for this adapter cable we use a special heat shrink tubing with hot melt adhesive for the assembly. The heat shrink tubing with hot melt adhesive serves both to seal the joints of the plug and sleeve and at the same time as kink protection. The shielding is what countsSome OM's use the thin RG 178 or RG 316 Chinese cables, which have a small diameter and are therefore very flexible. Unfortunately such cables have only a very low shielding of partly less than 25dB. But especially on the last meters you should have the highest shielding! Why? The house is teeming with potential interferers such as switching power supplies, LEDs, induction stove, etc.. Also the PC and the monitor are usually in direct proximity and can have unsightly influences. If it should be nevertheless a very thin coaxial cable, we offer the adapter cables from the flexible RG316DS PTFE coaxial cable, which has with 70dB the a good shielding. This greatly minimizes interference already on the way into the receiver. Important! Please note:Total length of the cable: cable cut +/- 3% + connector.

Mini adapter cable Very short, flexible adapter cable made of Hyperflex 5 for short connections in top quality. The mini adapter cable is the ideal solution if you either want to connect two devices of different sizes or need a short, flexible coax connection. If you want to connect small SDRs like the Airspy HF+ with accessories like the GI300/or GI1000, there is often a problem: the BNC adapter and the GI300 or GI1000 are much bigger than the HF+ SDR receiver. Now you could use a regular adapter cable, but since the GI300/1000 separates the ground from the line, the cable must be as short as possible, but still flexible enough to bridge the height difference. Also, it is often not a good idea to plug the GI 1000 directly into a device, as the weight could damage the socket. This mini adapter cable consists of a short piece of Hyperflex 5 with SMA or BNC connectors. The result is impressive and works very well.

Adapter cable BNC to 3.5mm jack plug Hyperflex 5 Adapter cable BNC-jack made of Hyperflex 5 by Messi&Paoloni low loss coaxial cable to connect external antennas with BNC-plug to the antenna input of a World Band Receiver (3,5mm jack) Most word band receivers have an external antenna connection which is a 3.5mm jack socket. If you want to use an external antenna with BNC connection, you need an adapter. Since the standard adapter jack on PL, then further from PL to BNC, are much too large and bulky for the radios, the jack socket on the receiver quickly turns off and contact difficulties occur after a short time. In the worst case, the jack must be replaced. With this adapter cable the jack socket of the World Band Receiver is relieved and in most cases you can connect the external antenna / the bias tee directly.  The available lengths are based on most customers needs. Other lengths are available and can be delivered according to your request.  Should you need other lengths or plugs, please, contact us; we are happy to help. Informationen about the cable The Hyperflex 5 cable is a doubly shielded low loss coax cable with a 5.4mm diameter. It is extremely flexible with a very low dampening factor and excellent shielding.  We have discribed the major differences between Hyperflex 5 and RG58U with many real examples in a Bonito Newsroom article: "Why even good antennas need good Coax cable": Read more Please note! These cables are custom-made and therefore are not returnable / refundable.

Adapter cable BNC to 3.5mm jack plug Adapter cable BNC-jack made of H155 low loss coaxial cable to connect external antennas with BNC-plug to the antenna input of a World Band Receiver (3,5mm jack) Most word band receivers have an external antenna connection which is a 3.5mm jack socket. If you want to use an external antenna with BNC connection, you need an adapter. Since the standard adapter jack on PL, then further from PL to BNC, are much too large and bulky for the radios, the jack socket on the receiver quickly turns off and contact difficulties occur after a short time. In the worst case, the jack must be replaced. With this adapter cable the jack socket of the World Band Receiver is relieved and in most cases you can connect the external antenna / the bias tee directly.  The available lengths are based on most customers needs. Other lengths are available and can be delivered according to your request.  Should you need other lengths or plugs, please, contact us; we are happy to help. Informationen about the cable The H 155 cable is a doubly shielded low loss coax cable with a 5.4mm diameter. It is extremely flexible with a very low dampening factor and excellent shielding.  We have discribed the major differences between H155 and RG58U with many real examples in a Bonito Newsroom article: "Why even good antennas need good Coax cable": Read more Please note! These cables are custom-made and therefore are not returnable / refundable.