CCMC30 Common Mode Noise Filter

MegActiv MA305FT Wide Band Active Antenna Wide frequency range 9kHz – 300MHz Small dimensions Dual Power Supply: 5,5V – 15V Selectable FM band stop filter with low pass function Ideal for traveling, at home or DX-Camps IP3:>typ. +30dBm / IP2:>typ. +50dBm Enlarged and flexible 200mm radiating element The new MegActiv MA305FT is an evolution of the popular MegActiv MA305. In addition to small improvements in electronics, the new MegActiv MA305FT has been equipped with a switchable FM band-stop filter. Thus, disturbing radiation from the FM band between 88 and 108 MHz can be easily minimized The new MegActiv MA305FT close the gap between the Boni-Whip and the GigActiv GA3005 E-Field Antennas. This low noise active antenna, which is produced according to the highest standards, covers the frequency range between 9kHz and 300MHz. With a radiating element of only 22 cm / 8,66 inch it can be erected inconspicuously. It can be powered with 5-15 V DC (max.10mA) and alternatively with the supplied Power unit CPI 1500DP via USB. Flexible FM-band stop filter Based on the well proven Megactiv platform, an additional low pass filter and a FM-band stop filter were integrated which can be activated or deactivated with a jumper. In case of FM-interferences, the FM bandstop filter can be activated with a jumper and so FM signals between 88 MHz and 108 MHz will be attenuated by 25 – 40 dB. Flexible power supply The MegActiv MA305FT can be operated by two different kinds of power sources. It can be powered either by a conventional plug power supply (5,5 / 2,1mm round plug) or via USB with a optional Cable. Powering via USB has the advantage that no external power supply is needed and that the antenna can be operated  autonomously and noise-free with a separate USB PowerBank. The supply voltage range is 5 - 15V DC (10mA max) and thus the antenna is also well suited for portable use. You want to test the MegActiv MA305FT live on air? If you would like to test the MegActiv MA305FT active antenna live, you can now conveniently do this over the Internet with a KIWI SDR. Just click on this Link and you can browse the whole band from 10kHz to 30MHz. The linked KIWI-SDR with a MegActiv MA305FT is located in Bonn (DL0DTM Clubstation Deutsche Telekom) and can handle up to 4 users at a time. Features Integrated double surge protection of the active components: Coarse protection by gas discharge tubes with 60V firing voltage with max. pulse leakage current 1kA (8/20µs) with additional integrated ESD fine protection of max. 2kV. Standard delivery with Power unit CPI1500DP (external power supply and USB-operation possible) IP3:>typ. +30dBm IP2:>typ. +50dBm Integrated double overvoltage protection of the active antenna part Integrated double surge protection of the active components: Coarse protection by gas discharge tubes with 60V firing voltage with max. pulse leakage current 1kA (8/20µs) with additional integrated ESD fine protection of max. 2kV. Fernando from Fenu-Radio.ch did the first comparison Test in Mai 2015 and released this test on his Page in German: www.fenu-radio.ch. Quote from the review by FenuRadio: (translated) "The NTi MegActiv is a small receiving antenna with excellent reception performance. The construction proved to be unproblematic, similar to the Boni-Whip. From VLF up on the FM band, the MegActiv receives very well despite their small size. When properly setup it provides a nearly unbeatable signal / noise ratio!" Whats in the box? MegActiv MA305FT Whip / Radiator Junction box CPI1500DP Made in Germany Please note! The offered coax cables are custom-made and therefore not returnable / refundable.

Mini adapter cable Very short, flexible adapter cable made of Hyperflex 5 for short connections in top quality. The mini adapter cable is the ideal solution if you either want to connect two devices of different sizes or need a short, flexible coax connection. If you want to connect small SDRs like the Airspy HF+ with accessories like the GI300/or GI1000, there is often a problem: the BNC adapter and the GI300 or GI1000 are much bigger than the HF+ SDR receiver. Now you could use a regular adapter cable, but since the GI300/1000 separates the ground from the line, the cable must be as short as possible, but still flexible enough to bridge the height difference. Also, it is often not a good idea to plug the GI 1000 directly into a device, as the weight could damage the socket. This mini adapter cable consists of a short piece of Hyperflex 5, about 10-14cm long and SMA or BNC connectors. The result is impressive and works very well.

GigActiv GA3005 Extreme Wideband Active Antenna Frequency range : 9 kHz - 3 GHz Power Supply: 5,5V - 12V Gain: + 3dB Upper Frequency Limit (-1db): 3000 MHz IP3: > +30 dBm typ. IP2: > +50 dBm typ. Where space is at a premium or you live in an area where an antenna is considered an undesirable element in neighborhood, the new GigActiv GA3005 is the ideal solution for the avid listener with a wide band receiver. The low noise GigActiv 3005 Extreme Wideband Active Antenna by NTi covers the whole frequency range from 9 kHz – 3 GHz. The antenna radiator measures only 10 cm (approx 4 inches) and so the unit can be mounted unobtrusively. The antenna requires a supply voltage of  5 –12V DC  (max. 120mA) fed through the coax cable via the standard supplied  DC interface CPI3000DP. It can also be powered via USB with slightly reduced performance. This is perfect for portable use in combination with a PC, which powers the antenna or the antenna can be powered autonomously and noise-free with a separate USB power bank. For shortwave and above 200MHz an IP3 of  typically > +30dBm is achieved. USB-powering possibleLarge supply voltage range of 5-12V. Thus it can be powered by a regular 12 Volt power supply or even via USB. Autonomously and noise- free via a separate USB Power Bank as well. Whats in the Box?- GigActiv GA3005- Radiator- Junctionbox CPI3000DP (DC interface) Dimesions incl Radiator:185 x 57 x 35mm  (7.28 x 2,24 x 1,38 inch) Made in Germany Please note! The offered coax cables are custom-made and therefore not returnable / refundable.

OMG ?! This antenna will amaze you! The MegaDipole 300DX is a broadband active dipole with a maximum upper working frequency of 300 MHz. The dipole reacts to the electrical component (E-Field) of the electromagnetic field and will deliver best results regarding signal strength and SNR (signal -to-noise-ratio) at locations with little or no locally generated interference. Nonetheless, the receiver to be coupled to this antenna should have a high enough dynamic range so that it can effectively process the received signals. In contrast to simple E-field antennas with only one radiating element, the symmetrical construction of the MegaDipole 300DX, will result in almost no negative resonance effects or reflections caused by the coaxial cable. First choice for DXer The MegaDipol MD300DX is the ideal antenna for DXers. Particularly in electrically quiet environments, it can really play to its strength in efficiently amplifying weak signals. In practical operations, a maximum signal-to-noise ratio of 110dB was achieved! (see image ) Wideband With prodigious broadband capability and constant receive characteristics the MegaDipol MD300DX is ideal for wideband receivers, SDR's and WEB-SDR such as KiwiSDR etc. The MegaDipol MD300DX can of course also be operated on all other receivers, including lower-end SDRs and portable world receivers. Dual Power Power Supply The MegaDipol is nominally supplied with 10 - 15V DC (max 40mA), however, it can be operated across a wide variety of supply voltages. The antenna can even be operated with slightly reduced IP values at the same gain with only 5 volts via USB. This offers a significant advantage in that you can supply the MegaDipol on trips away from the radio shack or DX expeditions autonomously, using a low-noise USB power-bank. "The MegaDipol has already attracted a lot of attention with its receive performance at various events such as DX-Camps, field days and in-house exhibitions. In these tests, the MD300DX surpassed the existing antennas usually by 10-15dB in the SNR." You want to test the MegaDipol MD300DX live on air? If you would like to test the MegaDipol MD300DX live, you can now conveniently do this over the Internet with a KIWI SDR. Just click on this Link and you can browse the whole band from 10kHz to 30MHz. The linked KIWI-SDR with a vertical MegaDipol MD300DX is in Ireland and can handle up to 4 users at a time. Further test links: KIWI-SDR in Norway, south of Oslo: LINK Customer Feedback"MegaDipol has arrived and installed. It seems to be a great antenna, especially compared to dimensions!" Technical data Frequency range: 9kHz - 300MHz IP3: typ. +30dBm (@7.00 & 7.20MHz) IP2: typ. +78dBm (@7.00 & 7.20MHz) Size/weight: 98 x 90 x 38mm / 0.12kg Whats in the Box? MegaDipol MD300DX Power Inserter CPI 1500UNI 2x 2.5m long radiating elements (PVC-coated, salt-water resistant stainless steel ropes) 2 insulators for installation (weatherproof plastic material with 4.5mm fixing hole) As noted previously, it is important that the connected receiver has a correspondingly high dynamic range in order to be able to optimally process the delivered signals. Recommendation Near the sea or in case of possible contact with salt water we strongly recommend the use of our weather protection case. Please note! The offered coax cables are custom-made and therefore not returnable / refundable.